Compaq SW3323 Manual De Usuario
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-2
User Interface
Writer: Fran Spragens Project: User Interface Comments:
File Name:3324_3.doc Last Saved On:3/16/99 3:05 PM
User Access
There are two modes of access to the user interface: READ-ONLY and
READ/WRITE. READ-ONLY access allows you to view switch information,
but not modify any operating parameters. READ/WRITE access allows you to
both read and modify switch information. You are required to login with a
password before obtaining READ/WRITE access. The factory default password
is “public” (lower case), allowing full READ/WRITE access until a new
password is set.
READ/WRITE. READ-ONLY access allows you to view switch information,
but not modify any operating parameters. READ/WRITE access allows you to
both read and modify switch information. You are required to login with a
password before obtaining READ/WRITE access. The factory default password
is “public” (lower case), allowing full READ/WRITE access until a new
password is set.
To use the console menus, do the following:
1. Type the letter associated with the desired option.
1. Type the letter associated with the desired option.
If the selected item is a submenu title, the submenu is displayed when you
enter the letter.
enter the letter.
2. Enter the parameter requested by the screen prompt.
If the selected item is a parameter, the system displays a prompt for the
entry of a new parameter value. If the value entered is invalid, a beep
sounds, or a message displays, requesting you to enter a valid value.
entry of a new parameter value. If the value entered is invalid, a beep
sounds, or a message displays, requesting you to enter a valid value.
Factory Defaults
Table 3-1 lists the factory default settings for the switch configuration
parameters. Each of these parameters can be changed via the console menus or
Telnet.
parameters. Each of these parameters can be changed via the console menus or
Telnet.