DELL 9.8(0.0) Manual De Usuario

To delete the site-of-origin community, use the no set extcommunity 
command.

Parameters

as4 ASN4:NN

Enter the keyword as4 then the 4-octet AS specific 
extended community number in the format ASN4:NN (4-
byte AS number:2-byte community value).

Enter the 2-octet AS specific extended community number 
in the format ASN:NNNN (2-byte AS number:4-byte 
community value).

Enter the IP address specific extended community in the 
format IPADDR:NN (4-byte IPv4 Unicast Address:2-byte 
community value).

non-trans

(OPTIONAL) Enter the keywords non-trans to indicate a 
non-transitive BGP extended community.

Defaults

none

Command 
Modes

ROUTE MAP (config-route-map)

Command 
History

This guide is platform-specific. For command information about other platforms, 
refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version 
8.3.19.0

Introduced on the S4820T.

Version 8.3.11.1

Introduced on the Z9000.

Version 8.3.7.0

Introduced on the S4810.

Version 7.8.1.0

Introduced on the S-Series.

Version 7.7.1.0

Introduced on the C-Series.

Version 7.6.1.0

Introduced on the E-Series.

Usage 
Information

If the set community rt and soo are in the same route-map entry, the behavior 
defines as:

• If the rt option comes before soo, with or without the additive option, soo 

overrides the communities rt sets.

• If the rt option comes after soo, without the additive option, rt overrides 

the communities soo sets.

• If the rt with the additive option comes after soo, rt adds the communities 

soo sets.

Related 
Commands

 — sets the extended community route origins using the route-

map.

530

Border Gateway Protocol