DELL 9.8(0.0) Manual De Usuario
Parameters
10
Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
NOTE: This interface speed is not supported on the LC-
EH-GE-50P or the LC-EJ-GE-50P card. If the command
is entered for these interfaces, an error message appears.
EH-GE-50P or the LC-EJ-GE-50P card. If the command
is entered for these interfaces, an error message appears.
100
Enter the keyword 100 to set the interface’s speed to 10/100
Mb/s.
Mb/s.
NOTE: When this setting is enabled, only 100Base-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
1000
Enter the keyword 1000 to set the interface’s speed to 1000
Mb/s. Auto-negotiation is enabled. For more information,
refer to negotiation auto.
Mb/s. Auto-negotiation is enabled. For more information,
refer to negotiation auto.
NOTE: When this setting is enabled, only 100oBase-FX
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
optics are supported on the LC-EH-GE-50P or the LC-
EJ-GE-50P card.
auto
Enter the keyword auto to set the interface to auto-
negotiate its speed. Auto-negotiation is enabled. For more
information, refer to negotiation auto.
negotiate its speed. Auto-negotiation is enabled. For more
information, refer to negotiation auto.
Defaults
auto
Command
Modes
Modes
INTERFACE
Command
History
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.3.1.0
Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards.
8.1.1.0
Introduced on the E-Series ExaScale.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
E-Series legacy
command
command
850
Interfaces