Nortel Networks 4500 Manual De Usuario
24 Chapter 1 Contivity 4600 Option Installation
302283-E Rev 00
7
Plug in both power cords to the power source and turn on the switch.
Installing Contivity 4600 DIMMs
shows you how to unlock a DIMM in the Contivity 4600, and remove or
install a DIMM. Install a DIMM in the next available slot (for example, if the
DIMM #1 slot is populated, then add the next DIMM to the DIMM #2 slot).
DIMM #1 slot is populated, then add the next DIMM to the DIMM #2 slot).
To install a DIMM in the Contivity 4600, follow these steps:
1
Turn off the switch and unplug both power cords from the power source.
2
Unscrew the four slotted thumb-screws securing the slide-out tray. Pull out
the tray by gripping it with the screws. It will only pull out halfway.
the tray by gripping it with the screws. It will only pull out halfway.
3
Unscrew the slide-out tray at the back of the unit and pull it out using the
thumb screws.
thumb screws.
4
Remove the support bracket by loosening the two secured captive screws and
the rear Phillips screw.
the rear Phillips screw.
5
Press down the locking levers on both sides of the next available DIMM slot.
6
Place a new DIMM in the slot, making sure to properly position the DIMM's
alignment keys, as shown in
alignment keys, as shown in
.
Caution: Be careful when inserting option cards into the Contivity
4600, because the slide-out tray is not fully supported once pulled out.
You should support the back of the tray with your hand while inserting
an option card.
4600, because the slide-out tray is not fully supported once pulled out.
You should support the back of the tray with your hand while inserting
an option card.