Nortel Networks 4500 Manual De Usuario

Installing Hardware Options for the Contivity VPN Switch

 

This chapter describes how Nortel Networks trained service personnel can change 
existing hardware configurations, including installing LAN and WAN cards for 
the Contivity 600. 

To install LAN or WAN cards you must: 

Remove the power cable.

Remove all signal cables.

Remove the four screws on the bottom of the switch.

Slide the inner chassis out of the casing. 

Unscrew the PCI interface bracket screw and remove the PCI interface card or 
blank PCI bracket. 

Install a new PCI interface, being careful to completely press the card into the 
PCI connector on the mother board. 

Replace the chassis (along the guide rails) in the outer casing.

Replace the bottom screws. 

Note: The expansion slot is renamed to Slot 2 by the Contivity 600 
software.

Warning: Wear an antistatic band when handling electronic 
components for the Contivity 600 to avoid damaging them.

Note: Unplug the power cord from the rear of the Contivity 600 before 
installing LAN or WAN interface cards.