3com 5500-SI Manual De Usuario
180
C
HAPTER
13: MSTP C
ONFIGURATION
Configuration example
Enable MSTP on the switch and disable MSTP on port Ethernet1/0/1.
1 Configure in system view.
<S5500> system-view
System View: return to User View with Ctrl+Z.
[S5500] stp enable
[S5500] stp interface ethernet1/0/1 disable
2 Configure in Ethernet port view.
<S5500> system-view
System View: return to User View with Ctrl+Z.
[S5500] stp enable
[S5500] interface ethernet1/0/1
[S5500-Ethernet1/0/1] stp disable
Leaf Node
Configuration
Configuration
Table 159 lists the MSTP configuration tasks for leaf nodes.
With both GVRP and MSTP enabled on switches, GVRP packets will be forwarded
along the CIST. If you want to broadcast packets of a specific VLAN through GVRP, be
sure to map the VLAN to the CIST when configuring the MSTP VLAN mapping table.
The CIST of a network is the spanning tree instance numbered 0.
along the CIST. If you want to broadcast packets of a specific VLAN through GVRP, be
sure to map the VLAN to the CIST when configuring the MSTP VLAN mapping table.
The CIST of a network is the spanning tree instance numbered 0.
Prerequisites
Before configuration, determine what roles the switches will play in the spanning
trees, that is, whether a switch will be the root, a branch, or a leaf in a spanning tree
trees, that is, whether a switch will be the root, a branch, or a leaf in a spanning tree
Configuring an MST
Region
Refer to “Configuring an MST Region”.
Table 159 Leaf node configuration
Operation
Description
Related section
Enable MSTP
Required
Normally, to reduce network
topology jitters caused by
configuration, you are
recommended to enable
MSTP after completing other
related configurations.
Normally, to reduce network
topology jitters caused by
configuration, you are
recommended to enable
MSTP after completing other
related configurations.
Configure an MST region
Required
Configure MSTP operation mode
Optional
Configure the timeout time factor Optional
Configure the maximum
transmission speed of a port
transmission speed of a port
Optional
The default is recommended.
Set a port as an edge port
Optional
Configure the path cost of a port
Optional
Configure the priority of a port
Optional
Configure a port to connect to
point-to-point link
point-to-point link
Optional