3com 5500-SI Manual De Usuario
476
C
HAPTER
22: F
ILE
S
YSTEM
M
ANAGEMENT
4 Configuring loghost
The configuration on the loghost must be the same with that on the Switch. For
related configuration, see the configuration examples in the latter part of this chapter.
related configuration, see the configuration examples in the latter part of this chapter.
Setting Format of Time Stamps Due to be Sent to Log Host
Table 532 describes the detailed configuration tasks on the switch.
If users require debugging messages for some modules of the switch, they need to
specify the type of information as debug while setting information source, and to
enable debugging for the corresponding modules using the debugging command.
specify the type of information as debug while setting information source, and to
enable debugging for the corresponding modules using the debugging command.
Sending the Information
to Control Terminal
To send information to the control terminal, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 533 Enable/disable info-center
Info-center is enabled by default. After info-center is enabled, system performances
are affected when the system processes much information because of information
classification and outputting.
are affected when the system processes much information because of information
classification and outputting.
2 Configuring to output information to the control terminal.
Perform the following operation in Table 534.
Table 532 Configure the information to be sent to log host
Operation
Command
Description
Enter system view
system-view
-
Enable information
center
center
info-center enable
Optional;
Enabled by default.
Enabled by default.
Output information to
log host
log host
info-center loghost host-ip-addr [
channel { channel-number | channel-name
} | facility local-number | language {
chinese | english } ]
channel { channel-number | channel-name
} | facility local-number | language {
chinese | english } ]
Required;
By default, the switch
does not send information
to log host.
By default, the switch
does not send information
to log host.
Enter the proper IP
address. The system will
take loopback addresses
as invalid and indicate as
such.
address. The system will
take loopback addresses
as invalid and indicate as
such.
Specify the interface
that sends log
information to log host
that sends log
information to log host
info-center loghost source interface-type
interface-number
interface-number
Optional
Define source of
information
information
info-center source { modu-name |
default } channel { channel-number |
channel-name } [ { log | trap | debug } * {
level severity | state state } * ]
default } channel { channel-number |
channel-name } [ { log | trap | debug } * {
level severity | state state } * ]
Required
Set the format of time
stamps to be sent to log
host
stamps to be sent to log
host
info-center timestamp loghost { date |
no-year-date | none }
no-year-date | none }
Optional
Operation
Command
Enable info-center
info-center enable
Disable info-center
undo info-center enable