3com 5500-SI Manual De Usuario
482
C
HAPTER
22: F
ILE
S
YSTEM
M
ANAGEMENT
modu-name
specifies the module name;
default
represents all the modules;
level
refers to the severity levels;
severity
specifies the severity level of information. The
information with the level below it will not be output.
channel-number
specifies the
channel number and
channel-name
specifies the channel name.
When defining the information sent to the trap buffer,
channel-number
or
channel-name
must be set to the channel that corresponds to the Console direction.
Every channel has been set with a default record, whose module name is
default
and the module number is 0xffff0000. However, for different channels, the default
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
record may have different default settings of log, trap and debugging. When there is
no specific configuration record for a module in the channel, use the default one.
If you want to view the debugging information of some modules on the Switch, you
must select
must select
debugging
as the information type when configuring information source,
meantime using the
debugging
command to turn on the debugging Switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
information and the time-stamp output format of trap information.
Perform the following operation in System View.
Table 550 Configuring the Output Format of Time-stamp
Sending the Information
to SNMP Network
Management
To send information to SNMP NM, follow the steps below:
1 Enabling info-center
Perform the following operation in System View.
Table 551 Enabling/Disabling Info-center
Info-center is enabled by default. After info-center is enabled, system performances
are affected when the system processes much information because of information
classification and outputting.
are affected when the system processes much information because of information
classification and outputting.
2 Configuring to output information to SNMP NM
Perform the following operation in System View.
Table 552 Configuring to Output Information to SNMP NM
Operation
Command
Configure the output format of
the time-stamp
the time-stamp
info-center timestamp { log | trap |
debugging } { boot | date | none }
debugging } { boot | date | none }
Output time-stamp is disabled
undo info-center timestamp { log | trap |
debugging }
debugging }
Operation
Command
Enable info-center
info-center enable
Disable info-center
undo info-center enable
Operation
Command
Output information to SNMP NM
info-center snmp channel {
channel-number
channel-number
| channel-name }
Cancel the configuration of outputting
information to SNMP NM
information to SNMP NM
undo info-center snmp channel