3com 5500-SI Manual De Usuario

The following command is used to automatically run a 

command after you log in. After a command is configured to be run automatically, it 
will be automatically executed when you log in again.

This command is usually used to automatically execute the 

 command on the 

terminal, which will connect the user to a designated device automatically.

Perform the following configuration in User Interface View.

Note the following points:

■

After executing this command, the user interface can no longer be used to carry 
out the routine configurations for the local system. Use this command with 
caution.

■

Make sure that you will be able to log in the system in another way and cancel the 
configuration, before you use the 

 command and save the 

configuration.

Telnet 10.110.100.1 after the user logs in through VTY0 automatically.

[SW5500-ui-vty0]auto-execute command telnet 10.110.100.1

When a user logs on through VTY 0, the system will run 

 10.110.100.1 

automatically.

After the above configuration, use the 

 command in any view to display the 

running of the user interface configuration, and to verify the effect of the 
configuration.

Use the 

 command in User View to clear a specified user interface.

Table 28   Configuring to Automatically Run the Command

Configure to automatically run the command

 text

Configure not to automatically run the 
command

Table 29   Displaying and Debugging User Interface

Clear a specified user interface

 [ type ] number

Display the user application information 
of the user interface

 [ all ]

Display the physical attributes and some 
configurations of the user interface

 [ type number | 

 ] [ summary ]