3com 5500-SI Manual De Usuario
612
C
HAPTER
32: C
LUSTERING
2 Configure member devices (take one member as example)
a Enable system NDP and port NDP on port Ethernet1/1.
[S5500] ndp enable
[S5500] interface ethernet 1/1
[S5500-Ethernet1/1] ndp enable
b Enable system NTDP and port NTDP on port Ethernet1/1.
[S5500] ntdp enable
[S5500] interface ethernet 1/1
[S5500-Ethernet1/1] ntdp enable
c Enable the cluster function.
[S5500] cluster enable
3 After adding the two switches to the cluster, perform the following configurations on
the member device.
a Establish a connection with the cluster FTP server.
<aaa_1.S5500> ftp cluster
b Download the file named aaa.txt from the cluster TFTP server.
<aaa_1.S5500> tftp cluster get aaa.txt
c Upload the file named bbb.txt to the cluster TFTP server.
<aaa_1.S5500> tftp cluster put bbb.txt
Upon the completion of the above configurations, you can execute the cluster
switch-to { member-number | mac-address H-H-H } command on the management
device to switch to member device view to maintain and manage a member device.
You can then execute the cluster switch-to administrator command to resume the
management device view.
switch-to { member-number | mac-address H-H-H } command on the management
device to switch to member device view to maintain and manage a member device.
You can then execute the cluster switch-to administrator command to resume the
management device view.
You can also reboot a member device by executing the reboot member {
member-number | mac-address H.H.H } [ eraseflash ] command on the
management device. For detailed information about these configurations, refer to the
preceding description in this chapter.
member-number | mac-address H.H.H } [ eraseflash ] command on the
management device. For detailed information about these configurations, refer to the
preceding description in this chapter.
After the above configuration, you can check cluster member log and SNMP trap
messages through the SNMP host.
messages through the SNMP host.
NM Interface for Cluster
Management
Configuration Example
Network requirements
Configure Vlan-interface2 as the NM interface.
Specify VLAN 3 as the management VLAN.
Configure the devices as follows:
■
The IP address of the FTP server is 192.168.4.3.
■
Switch 5500 is the management switch.
■
S3526E and S2403 are managed switches.
Table 670 Connection of the management switch
VLAN (connect to other
switch or a server)
switch or a server)
IP address
Connection port
VLAN 3 (S3526E)
192.168.4.30/24
Ethernet 1/0/1
VLAN 2 (FTP Sever)
192.168.4.22/24
Ethernet 1/0/2