Manualsbrain.com
  1. Manuales
  2. Marcas
  3. 3com
  4. DUA1750-2BAA01
  5. Manual De Usuario

3com DUA1750-2BAA01 Manual De Usuario

Descargar
Página de 773
3Com Switch 8800 Configuration Guide 
Chapter 18  RIP Configuration
 
18-12 
18.3  Displaying and Debugging RIP 
After the above configuration, execute the display command in any view to display the 
running of the RIP configuration, and to verify the effect of the configuration. Execute 
the debugging command in user view to debug the RIP module. Execute the reset 
command in RIP view to reset the system configuration parameters of RIP.  
Table 18-17 Display and debug RIP 
Operation
 
Command
 
Display the current RIP running state and 
configuration information. 
display rip 
Enable the RIP packet debugging information 
debugging rip packet 
Disable the RIP packet debugging information 
undo debugging rip packet 
Enable the debugging of RIP receiving packets 
debugging rip receive 
Disable the debugging of RIP receiving packets 
undo debugging rip receive 
Enable the debugging of RIP sending packet 
debugging rip send 
Disable the debugging of RIP sending packet 
undo debugging rip send 
Reset the system configuration parameters of RIP
reset 
 
18.4  Typical RIP Configuration Example 
I. Network requirements 
As shown in Figure 18-1, switch C connects to the subnet 117.102.0.0 through the 
Ethernet port. The Ethernet ports of switches A and Switch B are respectively 
connected to the network 155.10.1.0 and 196.38.165.0. Switch C, Switch A and Switch 
B are connected via Ethernet 110.11.2.0. Correctly configure RIP to ensure that Switch 
C, Switch A and Switch B can interconnect with each other.