3com DUA1750-2BAA01 Manual De Usuario

3Com Switch 8800 Configuration Guide 

Chapter 26  Common Multicast Configuration

 

26-5 

[SW8800-GigabitEthernet2/1/1] dot1x   

[SW8800-GigabitEthernet2/1/2] dot1x   

Configure the authentication mode on the controlled ports to port-based mode. 

[SW8800-GigabitEthernet2/1/1] dot1x –method portbased 

[SW8800-GigabitEthernet2/1/2] dot1x –method portbased 

Create a local-user in system view. Then set the password and service type for the 

user. 

[SW8800] local-user liu 

[SW8800-luser-liu] password simple aaa 

[SW8800-luser-liu] service-type lan-access 

In user view, configure the allowed multicast group for the user to join. 

[SW8800-luser-liu] multicast 227.1.1.1   

After the above configuration, execute display command in any view to display the 

running of the multicast configuration, and to verify the effect of the configuration. 

Execute debugging command in user view for the debugging of multicast. 

Table 26-6 Displaying and Debugging Common Multicast Configuration 

Display the multicast routing table 

display multicast routing-table 
[ 

group-address [ mask { mask | 

mask-length } ] | source-address [ mask 
{ mask | mask-length } ] | incoming-interface 
{  vlan-interface vlan-interface-number  | 
register } ]* 

Display the multicast forwarding 
table 

display multicast forwarding-table 
[ 

group-address [ mask { mask | 

mask-length } ] | source-address [ mask 
{ mask | mask-length } ] | incoming-interface 
{  interface-type  interface-number  |  null 
NULL-interface- number | register } ]* 

Enable multicast packet forwarding 
debugging 

Disable multicast packet forwarding 
debugging 

Enable multicast forwarding status 
debugging 

Disable multicast forwarding status 
debugging