3com 4500 PWR 50-PORT Manual De Usuario
RSTP Configuration Commands
221
Parameter
enable:
Sets the current Ethernet port as an edge port.
disable:
Sets the current Ethernet port as a non-edge port.
Description
Use the
stp edged-port enable
command to configure the current port as an
edge port.
Use the
stp edged-port disable
command to configure the current port as a
non-edge port.
Use the
undo stp edged-port
command to restore the default setting.
By default, all the Ethernet ports of the bridge are configured as non-edge ports.
If the current Ethernet port is connected to other Switch, you can use the
stp
edged-port disable
or
undo stp edged-port
command to specify it as a
non-edge port. The stp edged-port enable command can be used to configure the
current Ethernet port as an edge port. All the Ethernet ports have been set to
non-edge ports by default. You can configure the Ethernet ports directly
connected to the user terminals as edge ports, so that they can transition to
forwarding state quickly.
current Ethernet port as an edge port. All the Ethernet ports have been set to
non-edge ports by default. You can configure the Ethernet ports directly
connected to the user terminals as edge ports, so that they can transition to
forwarding state quickly.
Related command:
stp point-to-point
.
Example
To set Ethernet1/0/1 as a non-edge port, enter the following:
<4500>system-view
System View: return to User View with Ctrl+Z.
[4500]interface Ethernet1/0/1
[4500-Ethernet1/0/1]stp edged-port disable
stp loop-protection
Syntax
stp loop-protection
undo stp loop-protection
View
Ethernet Port View
Parameter
none
Description
Use the
stp loop-protection
command to enable loop protection function.
Use the
undo stp loop-protection
command to restore the setting.
By default, the loop protection function is not enabled.