3com 4500 26-PORT Manual De Usuario
RIP Configuration Commands
151
Garbage-collection timer : 120
No peer router
Network :
202.38.168.0
filter-policy export
Syntax
filter-policy { acl_number | gateway gateway-ip | ip-prefix
ip_prefix_name } export [routing_process]
filter-policy route-policy route-policy-name export
undo filter-policy { acl_number | gateway gateway-ip | ip-prefix
ip_prefix-name } export [routing_process]
undo filter-policy route-policy route-policy-name export
View
RIP view
Parameters
acl_number
Enter the number of the ACL that you want to use to filter the
destination addresses of the routing information.
gateway-ip
ip_prefix_name
Enter the name of the address prefix list that you want to use to
filter the destination addresses of the routing information.
route-policy-name
: Route policy name that filters routing information. After
enabling RIP protocol, you can determine which routes are to be sent/received
based on acl/cost/interface/ip/ip-prefix/tag fields.
based on acl/cost/interface/ip/ip-prefix/tag fields.
routing_protocol
Enter the routing protocol whose routing information is to be
filtered. This can be one of the following:
■
direct
— Specifies direct routes
■
static
— Specifies static routes.
Table 22 Output Description of the
display rip
Command
Field
Description
RIP is running
RIP is active
Checkzero is on
Zero field checking is enabled
Default cost:1
The default route cost is 1
Summary is on
Routes are summarized automatically
Preference: 100
The preference of RIP is 100
Period update timer : 30
Timeout timer : 180
Garbage-collection timer : 120
The three RIP timers
No peer router
No destination address of a transmission is specified
Network: 202.38.168.0
RIP enabled on network segment 202.38.168.0