3com 4500 26-PORT Manual De Usuario

C

HAPTER

 11: U

SING

 AAA 

AND

 RADIUS C

OMMANDS

RADIUS Scheme View 

 Specifies the maximal retransmission times after stopping 

accounting request,. ranging from 10 to 65535. By default, the value is 500. 

Use the 

 command to configure the maximal 

retransmission times after stopping accounting request. Use the 

 command to restore the retransmission times to the default 

value. 

Because the stopping accounting request concerns account balance and will affect 
the amount of charge, which is very important for both the user and ISP, NAS shall 
make its best effort to send the message to RADIUS accounting server. 
Accordingly, if the message from the Switch to RADIUS accounting server has not 
been responded, the Switch shall save it in the local buffer and retransmit it until 
the server responds or discard the messages after transmitting for specified times. 

Related commands: 

, 

, 

.

To indicate that, when stopping accounting request for the server “3Com” in the 
RADIUS server group, the Switch will retransmit the packets for up to 1000 times, 
enter the following: 

<4500>system-view

System View: return to User View with Ctrl+Z.

[4500]radius scheme 3Com

[4500-radius-3Com]retry stop-accounting 1000

secondary accounting ip-address [ port-number ]

RADIUS Scheme View 

 IP address, in dotted decimal format. By default, the IP addresses of 

second accounting server is at 0.0.0.0. 

 Specifies the UDP port number, ranging from 1 to 65535. By 

default, the accounting service is provided via UDP 1813.

Use the 

 command to configure the IP address and port 

number for the second RADIUS accounting server. Use the 

 command to restore the IP address and port number to default 

values.