3com 4500 26-PORT Manual De Usuario

C

HAPTER

 12: U

SING

 S

YSTEM

 M

ANAGEMENT

 C

OMMANDS

Use the 

 command to configure the aging time of the Layer-2 

dynamic address table entry. Use the 

 command to 

restore the default value.

Setting the aging time on the switch to be too long or too short will cause the 
switch to broadcast data packets without MAC addresses, this will affect the 
operational performance of the switch. 

If the aging time is set too long, the switch will store out-of-date MAC address 
tables. This will consume MAC address table resources and the switch will not be 
able to update MAC address table according to the network change.

If aging time is set too short, the switch may delete valid MAC address table 
entries.

Configure the entry aging time of Layer-2 dynamic address table to be 500 
seconds.

<SW4500>sys

System View: return to User View with Ctrl+Z.

[SW4500]mac-address timer aging 500

This section describes the device management commands available on your Switch 
4500.

User view

 Path and name of APP file.

Use the 

 command to specify the app file used for booting next 

time.

You can not specify the app file stored in another Unit as the boot application of a 
Unit.

Specify the APP application used for booting next time.

<SW4500>boot boot-loader unit1>flash:/PLATV100R002B09D002.APP The 

specified file will be booted next time!

<SW4500>

boot bootrom file-path