SMC Networks SMC6750L2 Manual De Usuario
C
OMMAND
L
INE
I
NTERFACE
3-50
ip address
Use this command to set the IP address for this device. Use the no form
to restore the default IP address.
to restore the default IP address.
Syntax
ip address {ip-address netmask | bootp | dhcp}
no ip address
no ip address
• ip-address - IP address
• netmask - Network mask for the associated IP subnet. This mask
• netmask - Network mask for the associated IP subnet. This mask
identifies the host address bits used for routing to specific subnets.
• bootp - Obtains IP address from BOOTP.
• dhcp - Obtains IP address from DHCP.
• dhcp - Obtains IP address from DHCP.
Default Setting
IP address: 0.0.0.0
Netmask: 255.0.0.0
Netmask: 255.0.0.0
Command Mode
Interface Configuration (VLAN)
Command Usage
• You must assign an IP address to this device to gain management
access over the network. You can manually configure a specific IP
address, or direct the device to obtain an address from a BOOTP or
DHCP server. Valid IP addresses consist of four numbers, 0 to 255,
address, or direct the device to obtain an address from a BOOTP or
DHCP server. Valid IP addresses consist of four numbers, 0 to 255,
ip
default-gateway
default-gateway
Defines the default gateway through which an
in-band management station can reach this
device
in-band management station can reach this
device
GC
show ip interface Displays the IP settings for this device
PE
show ip redirects Displays the default gateway configured for
this device
PE
ping
Sends ICMP echo request packets to another
node on the network
node on the network
NE,
PE
PE
Command
Function
Mode Page