SMC Networks SMC6750L2 Manual De Usuario
C
OMMAND
L
INE
I
NTERFACE
3-90
Example
bridge-group portfast
Use this command to set a port to fast forwarding. Use the no form to
disable fast forwarding.
disable fast forwarding.
Syntax
bridge-group bridge-group portfast
no bridge-group bridge-group portfast
no bridge-group bridge-group portfast
bridge-group - Bridge group index (bridge 1).
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• This command is used to enable/disable the fast spanning-tree mode
for the selected port. In this mode, ports skip the Blocked, Listening
and Learning states and proceed straight to Forwarding.
and Learning states and proceed straight to Forwarding.
• Since end-nodes cannot cause forwarding loops, they can be passed
through the spanning tree state changes more quickly than allowed by
standard convergence time. Fast forwarding can achieve quicker
convergence for end-node workstations and servers, and also
overcome other STA related timeout problems. (Remember that fast
forwarding should only be enabled for ports connected to an end-node
device.)
standard convergence time. Fast forwarding can achieve quicker
convergence for end-node workstations and servers, and also
overcome other STA related timeout problems. (Remember that fast
forwarding should only be enabled for ports connected to an end-node
device.)
Example
Console(config)#interface ethernet 1/5
Console(config-if)#bridge-group 1 priority 0
Console(config-if)#
Console(config-if)#bridge-group 1 priority 0
Console(config-if)#
Console(config)#interface ethernet 1/5
Console(config-if)#bridge-group 1 portfast
Console(config-if)#
Console(config-if)#bridge-group 1 portfast
Console(config-if)#