SMC Networks SMC6750L2 Manual De Usuario
VLAN C
OMMANDS
3-101
switchport allowed vlan
Use this command to configure VLAN groups on the selected interface.
Use the no form to restore the default.
Use the no form to restore the default.
Syntax
switchport allowed vlan {add vlan-list [tagged | untagged] |
remove vlan-list}
no switchport allowed vlan
remove vlan-list}
no switchport allowed vlan
• add vlan-list - List of VLAN identifiers to add.
• remove vlan-list - List of VLAN identifiers to remove.
• remove vlan-list - List of VLAN identifiers to remove.
Separate nonconsecutive VLAN identifiers with a comma and no
spaces; use a hyphen to designate a range of IDs. Do not enter
leading zeros. (Range: 1-4094)
spaces; use a hyphen to designate a range of IDs. Do not enter
leading zeros. (Range: 1-4094)
Default Setting
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
The default frame type is untagged.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
You must enter the switchport mode command before the switchport
allowed vlan command can take effect.
allowed vlan command can take effect.
Example
The following example shows how to add VLANs 1, 2, 5 and 6 to the
allowed list as tagged VLANs for port 1:
allowed list as tagged VLANs for port 1:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport allowed vlan add 1,2,5,6 tagged
Console(config-if)#
Console(config-if)#switchport allowed vlan add 1,2,5,6 tagged
Console(config-if)#