GarrettCom 6K32 Manual De Usuario

Magnum 6K32 Managed Switch            Installation and User Guide (02/05) 

 

36 

.

.

 

The Managed Magnum 6K32 Fast Ethernet copper ports can be set for either 

fixed 100Mb speed or N-way auto-negotiation per the IEEE802.3u standard. The 

selection is made via 6K-MNS software.  The factory default setting is for auto-

negotiation.  At 100Mb-fixed speed, the user may select half- or full-duplex mode by  

6K-MNS Software for each RJ-45 port separately. For detail information see Section 8 

(Optimizing Port usage) of Magnum 6K32 Software user guide (MNS-6K) . See Section 

(2.2.9 at page no.14) of this manual to access the “MNS-6K Software user-guide” 

One frequently-used application for the Managed 6K32 Switch copper ports is 

to connect one of them using a fiber media converter to another Switch in the network 

backbone, or to some other remote 100Mb device.  In this case, it is desirable to operate 

the fiber link at 100Mb speed, and at either half- or full duplex mode depending on the 

capabilities of the remote device.  Standard commercially available Fast Ethernet media 

converters mostly do not support auto-negotiation properly, and require that the switched 

port to which they are connected be at 100Mb fixed speed.  Attachment to 10/100 auto-

negotiation ports typically will not work properly.  The 6K32 Switch’s RJ-45 ports 

handle this situation by configuring the ports as per desire through MNS software port 

settings and can check the port status of each port after the change. 

When Magnum 6K32 RJ-45 copper ports are set for auto-negotiation and are 

connected to another auto-negotiating device, there are 4 different speed and F/H modes 

possible depending on what the other device supports.  These are: (1) 100Mb full-duplex, 

(2) 100Mb half-duplex, (3) 10 Mb full-duplex and (4) 10 Mb half-duplex. 

 

 

    General information - 

 -- the devices at both ends of the cable are capable of operation at either 10 

Mb or 100Mb speed and/or in full- or half-duplex mode, and can 

send/receive auto-negotiation pulses, and . . .  

 --  the second of the two connected devices is powered up*, i.e., when 

LINK is established for a port, or 

--   the LINK is re-established on a port after being lost temporarily. 

• 

NOTE  –  Some NIC cards only auto-negotiate when the computer system