GarrettCom 6K25 Manual De Usuario

Magnum 6K25 Managed Fiber Switch            Installation and User Guide (04/06) 

 

14 

.

.

 

 

The Magnum Combo 

six-port modules are also available 

with 4@ MTRJ 100Mb mm SFF 

fiber and 2@10Mb fiber mm ST 

ports, and with 4@ RJ45 10/100 

copper and 2@10Mb fiber mm ST 

ports. The    4@ RJ-45 + 2@ 10 Mb ST 

operation of the SFF fiber 

and the RJ-45 half  of the module is as described for those port types above.  For detailed 

information about 10Mb mm ST fiber half of the module, please check  section 2.2.5. 

The 4port @10Mb ST fiber modules behave the same as the 8@100Mb ST 

fiber modules except for the 10Mb speed. For ports numbering, ports 1, 2, 5, 6 are 

present, ports 3, 4. 7, 8 are not present. The default setup on the 10Mb fiber module is 

half-duplex, which allows the Magnum 6K25 Switch to connect to any 10Mb hub or 

media converter or almost any other device with a 10Mb fiber Ethernet port. User mode 

control per port through the MNS software is the same as the other 6K25 modules. The 

fiber ports support fiber cabling distances according to the 10BASE-FL standard, i.e., 

2km distance for multi-mode fiber. (Single-mode for up to 10Km distance may be 

available as a special order configuration). 

 

The Magnum 6K25 offered a wide option Gigabit speed with multiple choice 

for the modular slot. While up to two Gigabit modules (maxm.) can be configured in the 

modular slot. The Gigabit port option for the modular slot comes in couple of different 

configuration. The Giga port has been offered 

as  single Gigabit module comes in flavor of 

G+4(10/100 RJ-45 ports) or G+2 (100Mb fiber 

ports) as shown below . 

  1@ 1000Mb Fiber SC + 2@ 100Mb SC                      

TX       LK     RX

 

 

1                                          5