GarrettCom 6K25 Manual De Usuario

Magnum 6K25 Managed Fiber Switch            Installation and User Guide (04/06) 

 

29 

.

.

on the front-bottom and rear-top of the unit and four screws each on the sides.  Remove 

these screws. Once these are removed, the top cover is easily lifted off the chassis base. 

When the chassis top cover has been removed, the interior of the unit is exposed. 

  Figure 3.5.1a:   Removing Chassis Cover 

 Caution:  Be careful not to disturb the power supply. 

Looking down into the Magnum 6K25 unit, notice that there are individual PM 

installation spaces and female latch(white) connectors provided on the main board along 

with four stand-off’s for each 6KPM card position. (See Figure 3.5.1b). 

There are four PM slots (A, B, C and D) located on the front of the chassis cover. 

Looking into the vertical placed Chassis cover of the unit, there are three brackets with 

retaining screws (#256 flat head ) which hold each PM Face plate card slot securely. 

These six screws shown in the picture below are used to secure a PM face plate in 

position, but unscrew only four of the screws as shown in Fig. below. These screws are 

also used to secure the individual 6KPM cards screen plate which can be subjected to 

significant forces from the attached cables.  (See Figure 3.5.1c)