GarrettCom 6K25e Manual De Usuario

Magnum 6K25e Gigabit Fiber Switch Installation and User Guide (10/07)

www GarrettCom com

brackets and 6 #256 flat head screws. The brackets and screws have been

installed inside of the top cover as shown in Fig. 3.5.2h.

Fig. 3.5.2h Inside view of chassis cover (from the rear), showing the front panel

screen plates installed inside the chassis cover using brackets and screws

Step 8. Once all 6KPM cards have been installed (including faceplates for empty

slots), the chassis cover should be replaced. Make sure the chassis cover is

aligned properly before securing the enclosure.

NOTE(Gigabit Module only): The Gigabit port module installation on slot A, B and C
COTX require four bracket extender for each(slot A, B, or C COTX).

Attach the bracket

from the PCA to the center standoff on the main mother board. The bracket provide
the stability to the Gigabit module. The slot D can be configured with dual Gigabit
SFP ordualRj-45 or dual combo of SFP & RJ-45 modules only.

NOTE (

Reverse mount Model): The Reverse model require a LED Decal, (for

checking the speed, F/H, and activity status)

3.5.3

Removing 6KPM Cards

To properly remove a 6KPM card from the 6K25e Managed Fiber Switch,

follow the 3 steps below.

Step 1. Remove chassis cover See procedures in Section 3.5.1 above.

Caution: Be sure the power cord is unplugged.

Step 2. Remove retaining screws placed on top for the 6KPM and Face Plate

On the top of the daughter module there are six

retaining screws for each 6KPM card. These

screws are used to secure a 6KPM card in

position (see Figure 3.5.3a). Remove the three

standoffs holding the Granddaughter board with

the chassis. The screen faceplate screws out from

the inside front of the chassis cover by loosening