GarrettCom 6K32T Manual De Usuario

Magnum 6K32T & 6K32TRC Managed Switch          Installation and User Guide 05/07) 

 
 

61

 

 

.

.

 

ACT

F/H

ACT

F/H

 

Inside) option in one 6K-unit. In this Fig. the top 4-RJ45 ports are enhanced with POE 
option whereas as bottom 4- RJ-45 are normal MDIX ports. The 4-RJ45 POE module are 
also available with mix –n-match with fiber modules. Please check the ordering 
information  Sec.1.2. for all the various PI6K PoE modules option. 

The LEDs on 6KP8-RJ45- PoE module are slightly different compared to 

regular (non-PoE) RJ-45 modules as shown in Fig 2. When the PoE port is in use, the 
PoE LED is ON when connected properly to a 803.af compliant PD device on that port. 
When non-PoE devices are connected, the PoE LED is OFF. Operation of Ethernet data 
traffic is not affected by PoE. 

LINK and ACTIVITY LEDS are combined on the PoE modules into one LED 

that is marked as LINK/ACT, as shown in the diagram. 
 
 
 
 
 
 
 
 
 
 
 
PoE LEDs Summary 

• 

For PoE devices, each RJ-45 PoE port supports only 802.3af complaint 
devices. The PoE LED is ON when the attached PD is drawing power from the 
port. 

• 

For non-PoE devices connected, the PoE port will act as a normal RJ-45 port 
and the PoE LED is OFF.  No power is being sent out from the port. 

• 

The PoE ports in Magnum 6K’s with 48VDC power input act as a pass-
through, so the 48VDC power source must be strong enough to provide power 
to the 6K switch and to all the 8 RJ-45 ports with PD devices connected (up to 
15 watts per PoE port). 

• 

In the case where the 
48VDC power in not 
internally connected and 
no power is coming to 
the PoE ports for some 
reason, all the PoE port 
LEDs are ON 
simultaneously to 
indicate a trouble 
condition. The ports will 
still operate properly for 
data traffic. 

4

2                   4            

6                  

8

F/ 
H

PO
E

4

2                   4            

6                  

8

F/ 
H

PO
E