GarrettCom P62 Manual De Usuario

Magnum P62-Series Hardened Switches                               Installation and User Guide (11/03)

 

 

 

31 

An address-aging algorithm causes least-used addresses to fall out in favor of new 

frequently-used addresses.  To reset the address buffer, cycle power down-and-up.  
 
4.2 

All six RJ-45 ports independently support auto-negotiation for speed in 10BASE-T and 

100BASE-TX modes. Operation is according to the IEEE 802.3u standard. 

When a RJ-45 cable connection is made, and each time a LINK is enabled, auto-

negotiation takes place. The P62-Series advertises its capability for 10 or 100 Mbps speed, and 

the device at the other end of the cable should similarly advertise / respond and both sides will 

agree to the speed being used.  Depending upon the device connected, this will result in 

agreement to operate at either 10 Mbps or 100Mbps speed.   

When the ‘LK/ACT’ LED is ON, steady ON indicates LINK with no traffic, blinking 

ON indicates the port is transmitting / receiving.  The port has auto-negotiated for operation. (If a 

P62s RJ-45port is connected to a non-negotiating device, it will default to 10 Mbps speed and 

half-duplex mode, per the IEEE 802.3u standard).  

POWER:   Illuminates GREEN, steady on when power applied. 

SELF TEST:  Indicates the self-test at power up was not successful. 
F/H: 

ON = Full-Duplex and Link, OFF = Half-Duplex and / or no Link. 

LK/ACT: Per port, steady ON for LINK with no traffic, blinking indicates port is 

transmitting and receiving. 

Per port, ON = 100Mbps; OFF = 10 Mbps (when LINK is made). 

.

.