Avaya C460 Manual De Usuario
Chapter 2 Avaya C460 CLI Commands
114
Avaya C460 Reference Guide
Example:
To enable PoE on ports 1 to 3 of module three to High:
To enable PoE on ports 1 to 3 of module three to High:
set port redundancy
User level: read-write, admin.
Use the set port redundancy command to globally enables or disable the
redundancy pairs you have defined. Using this command will not delete existing
redundancy entries.
L Disable Spanning Tree before you can enable redundancy.
Use the set port redundancy command to globally enables or disable the
redundancy pairs you have defined. Using this command will not delete existing
redundancy entries.
L Disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy
{enable|disable}
Example:
port
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
priority
The priority level for powering the port:
• Critical
• High
• Low
• Critical
• High
• Low
C460-1# set port powerinline 3/1-3 high
Load detection process on ports 3/1-3 was set to High
C460-1# set port redundancy enable
All redundancy schemes are now enabled