John Deere SB1174 Manual De Usuario

OM 0408SB1174-A 

26

7. Figure 23: Insert the switch (item 4) in the 

switchbox (item 2), secure with the two nuts 
(items 1-3) provided with the switch, and 
screw the rubber cap (item 5) in the order 
shown on figure. 

8. Figure 24:  Place the switchbox (item 1) on 

the lever so to get a comfortable working 
position when the hand is on the knob and 
secure with the switchbox clamp (item 5), 
using two 1/4"NC x 3/4" bolts and two 1/4" 
lockwashers (items 

3-4) by placing the 

clamp so to not block the switchbox lower 
openings. 

NOTE:  Tighten bolts just enough to attach 
the switchbox to the lever solidly. DO NOT 
TIGHTEN TOO MUCH to avoid deforming 
the clamp. 

Connect the ring terminal of the 

ground wire (item 1) to a ground screw of the 
vehicle. 

10. Figure 21: Connect the fuse wire (item 3) to 

the tractor switch wire using a tap connector 
(item 5). 

11. Figure 21: Connect the actuator double wire 

(item 4) to the actuator (item 7). 

12. Figure 21: Cover all wires with the loom 

(item 6) and attach with tie wrap.