Brocade Communications Systems IPMC5000PEF Manual De Usuario

Output fields from the show ip pim mcache command (Continued)

upstream neighbor

Shows the upstream neighbor for the Source/RP based on the type of entry. For (*,G) it
shows the upstream neighbor towards the RP. For (S,G) entries it shows the upstream
neighbor towards the source.

Flags

Flags Represent Entry flags in hex format in the braces. And indicates the meaning of
the flags set in abbreviated string whose explanations are as below. Only shows the
flags which are set.

SM - Shows If the entry is created by PIM Sparse Mode

DM - Shows If DM mode entry is enabled

SSM - Shows If the SSM mode entry is enabled

RPT - Shows If the entry is on the Rendezvous Point (RP)

SPT - Shows If the entry is on the source tree

LSRC - Shows If the source is in a directly-connected interface

LRcv - Shows If the receiver is directly connected to the router

REG - if the data registration is in progress

L2REG - if the source is directly connected to the router

REGSUPP - if the register suppression timer is running

RegProbe

HW - Shows If the candidate for hardware forwarding is enabled

FAST - Shows If the resources are allocated for hardware forwarding

TAG - Shows If there is a need for allocating entries from the replication table

MSDPADV - Shows If RP is responsible for the source and must be advertised to its
peers.

NEEDRTE - Shows If there is no route to the source and RP is available

PRUNE - Shows If PIM DM Prune to upstream is required

RP

Show the IP address of the RP.

fast ports

Shows forwarding port mask.

AgeSltMsk

Shows the slot number on which active module expects ingress traffic.

L2 FID

Shows the hardware resource allocated for the traffic switched to receivers in the
ingress VLAN.

DIT

Shows the hardware resource allocated for routed receivers.

RegPkt

Shows Count of Packets forwarded due to the Register decapsulation.

AvgRate

Shows the average Rate of packets ingressing for this entry over 30 seconds.

IPv4 Multicast Protocols