Brocade Communications Systems IPMC5000PEF Manual De Usuario

After the hardware forwarding database (FDB) entry is made, the multicast traffic is switched only to the
VLAN hosts that are members of the multicast group. This can avoid congestion and loss of traffic on
the ports that have not subscribed to this IPv4 multicast traffic.

Examples

The following example shows the disabling of flooding of unregistered IPv4 multicast frames.

Brocade(config)# ip multicast disable-flooding

History

08.0.01

This command was introduced.

ipv6 max-mroute

Configures a limit to the number of IPv6 multicast routes supported.

Syntax

ipv6 max-mroute num

Command Default

The default is no limit.

Parameters

Configures the maximum number of IPv6 multicast routes supported.

Modes

VRF configuration mode

Usage Guidelines

The no form of this command restores the limit to the default value.

Examples

This example limits the number of IPv6 multicast routes supported on the VRF named my_vrf to 20.

Device(config)# vrf my_vrf

Device(config)# address-family ipv6

Device(config-vrf)# ipv6 max-mroute 20

History

8.0.10a

This command was introduced.

ipv6 mroute

Configures a static IPv6 route to direct multicast traffic along a specific path.

Syntax

ipv6 mroute [vrf vrf-name] ipv6-address-prefix/prefix-length { ethernet | ve | tunnel num } [cost ] [
distance distance-value ] [ name name ]

no ipv6 mroute [vrf vrf-name] ipv6-address-prefix/prefix-length { ethernet | ve | tunnel num } [cost ] [
distance distance-value ] [ name name ]

Command Default

No static multicast route is configured.

ipv6 max-mroute