Brocade Communications Systems 6710-54 Manual De Usuario

Overview

This Quick Start guide is intended as an overview to help experienced installers unpack, install, and configure the 
Brocade VDX 6710-54 quickly. For more detailed installation and configuration instructions, see the Brocade 
Network OS Administrator’s Guide and the Brocade Network OS Command Reference Manual.

NOTE

Throughout this document, the Brocade VDX 6710 is referred to as the switch.

Items included with the Brocade VDX 6710-54

The following items are included with the standard shipment of a fully-configured Brocade VDX 6710-54. When you 
open the Brocade VDX 6710-54 packaging, verify that the items are included in the package and that no damage 
has occurred during shipping:

•

The Brocade VDX 6710-54 switch

•

One accessory kit, containing the following items:

-

Serial cable with an RJ45 connector

-

6 ft. power cords (2)

-

Rubber feet, required for setting up the switch as a standalone unit

-

Installation and safety considerations

You can install a Brocade VDX 6710-54 switch in the following ways: 

•

As a standalone unit on a flat surface.

•

In an EIA four-post rack using a fixed-rail rack mount kit. The fixed-rail rack mount kit can be ordered from your 
switch retailer. 

•

In a Telco rack using a flush mount rack kit. The flush mount rack kit for switches can be ordered from your 
switch retailer. 

Electrical considerations

To install and operate the switch successfully, ensure compliance with the following requirements:

•

The primary outlet is correctly wired, protected by a circuit breaker, and grounded in accordance with local 
electrical codes.

•

The supply circuit, line fusing, and wire size are adequate, as specified by the electrical rating on the switch 
nameplate.

•

The power supply standards are met. Refer to 

 on page 4 for more information.