Brocade Communications Systems 53-1001761-01 Manual De Usuario

Default LLDP configuration

7

Default LLDP configuration

 lists the default LLDP configuration.

LLDP configuration and management

NOTE

You need to enter either the copy running-config startup-config command or the write memory 
command to save your configuration changes to Flash so that they are not lost if there is a system 
reload or power outage. 

Enabling LLDP globally

The protocol lldp command enables LLDP globally on all interfaces unless it has been specifically 
disabled on an interface. LLDP is globally enabled by default. 

To enable LLDP globally, perform the following steps from Privileged EXEC mode.

1. Enter the configure terminal command to access global configuration mode.

2. Enter LLDP configuration mode.

switch(config)#protocol lldp

Disabling and resetting LLDP globally

The protocol lldp command returns all configuration settings made using the protocol lldp 
commands to their default settings. LLDP is globally enabled by default. 

To disable and reset LLDP globally, perform the following steps from Privileged EXEC mode.

1. Enter the configure terminal command to access global configuration mode.

2. Disable LLDP globally. 

switch(config)#no protocol lldp

TABLE 13

Default LLDP configuration

Parameter Default 

setting

LLDP global state

Enabled

LLDP receive

Enabled

LLDP transmit

Enabled

Transmission frequency of LLDP updates

30 seconds

Hold time for receiving devices before discarding

120 seconds

DCBX-related TLVs to be advertised

dcbx-tlv