Brocade Communications Systems 800 Manual De Usuario
EZSwitchSetup Administrator’s Guide
15
53-1002157-01
Installing and running the EZSwitchSetup wizard
2
Switch discovery failure
During the setup of your switch, the switch discovery may fail. There may be several reasons why
switch discovery fails.
switch discovery fails.
lists symptoms and related suggestions to recover the switch.
TABLE 2
Discovery recovery
Symptom
Correction
For serial connections:
The setup computer COM port is busy.
The port is being controlled by another communications program.
Stop all other third-party communications programs.
Stop all other third-party communications programs.
The port settings are in conflict with another device. Check your
IRQ settings.
On Windows systems:
By default, COM1 and COM3 use IRQ4, while COM2 and COM4
use IRQ3. If another device is sharing the IRQ of the port, you
need to change the IRQ of the conflicting device. Hardware
conflicts can also occur with the I/O address of the COM port. The
8514a video chip or its clones (S3 chip set) on some video cards
create a conflict with COM4 because they use the same address
of 02E8.
IRQ settings.
On Windows systems:
By default, COM1 and COM3 use IRQ4, while COM2 and COM4
use IRQ3. If another device is sharing the IRQ of the port, you
need to change the IRQ of the conflicting device. Hardware
conflicts can also occur with the I/O address of the COM port. The
8514a video chip or its clones (S3 chip set) on some video cards
create a conflict with COM4 because they use the same address
of 02E8.
The switch does not respond to
commands during a serial connection.
commands during a serial connection.
The serial cable may not be connected properly between the
setup computer and the switch. Check the serial cable to ensure
they are secured.
setup computer and the switch. Check the serial cable to ensure
they are secured.
The switch does not power up.
Verify that the switch’s power cable is securely plugged into a
proper outlet and that the switch’s power button is turned on.
proper outlet and that the switch’s power button is turned on.
The switch’s serial adapter does not
work.
work.
Verify that the cable is good by replacing the cable or trying it on
another known working device.
If the cable is good, then call your support provider for further
instructions.
another known working device.
If the cable is good, then call your support provider for further
instructions.
For Ethernet connections:
The WWN is not entered correctly.
Verify that the WWN is correct.
The target switch is not on the same
subnet as the host.
subnet as the host.
Connect the host to the same subnet as the target switch. If it is
not possible or convenient to do so, use the serial connection to
set the IP address.
not possible or convenient to do so, use the serial connection to
set the IP address.
The target switch has no IP address
instead of the factory default
10.77.77.77.
instead of the factory default
10.77.77.77.
Use the serial connection to set the IP address.
You have requested automatic address
assignment in an environment where a
DHCP server is not available.
assignment in an environment where a
DHCP server is not available.
Use the serial connection to set a reachable address.