Brocade Communications Systems VA-40FC Manual De Usuario
10
EZSwitchSetup Administrator’s Guide
53-1002157-01
Installing and running the EZSwitchSetup wizard
2
If you are using an Ethernet LAN connection, a Discover Switch screen is displayed (
Go on to
FIGURE 7
First Discover Switch screen
Discovering the switch
1. Locate the WWN for your switch on the switch ID pull-out tab located on the bottom of the port
side of the switch.
2. From the Switch WWN list (
), choose the switch’s WWN prefix numbers and then enter
the last six alphanumeric digits of your switch’s WWN. Each two alphanumeric digits must be
separated by a colon.
separated by a colon.
3. Click Next.
When EZSwitchSetup discovers the switch, it displays the discovered IP addresses (IPv4 and
IPv6) on the screen (
IPv6) on the screen (
).
If you are setting up the switch for the first time, the IP addresses are placeholder addresses
that were assigned at the factory and you must provide valid addresses.
that were assigned at the factory and you must provide valid addresses.