Brocade Communications Systems 8770-4 Manual De Usuario

10. Before you apply power to the switch, you can install the MM, SFM, and line card modules as well as power 

supplies to speed up your installation. Refer to the following tasks for information on inserting thet various 
modules.

Port numbering

The Brocade VDX 8770-4 uses the following port numbering method:

•

12x40G line card module — Ports are numbered from 1 through 12 from from left to right when installed in the 
switch. Refer to 

FIGURE 3

12x40G line card

•

48x1G and 48x10G line card modules — Ports are numbered from 1 through 48, from left to right, with the 
odd-numbered ports on the upper row and the even-numbered ports on the lower row when installed in the 
switch. Refer to 

FIGURE 4

48x10G line card (48x1G line card similar)

Inserting a management module

For this procedure, refer to 

.

Complete the following steps to insert an MM.

1. Unpack the new MM and remove it from the anti-static bag.

2. Inspect the module for damage.

3. Remove the protective caps from the b ackplane connectors.

4. Rotate the ejectors toward the center of the module.

5. Align the module pan with the guides in the slot. The first MM should be installed in slot M1.

6. Slide the MM into the slot until it is firmly seated.

7. Rotate the ejectors away from the center of the module face until the module is tight in the slot.

8. Tighten the captive screws using the Phillips screwdriver.