Black Box ServSwitch Wizard VGA (USB) Manual De Usuario
ServSwitch Wizard VGA (USB)
724-746-5500 | blackbox.com
Page 18
724-746-5500 | blackbox.com
3.2.3 Power in connection
The ServSwitch Wizard VGA (USB) unit is supplied with either a 12.5W (single screen version) or 20W (Multiscreen versions)
power adapter. There is no on/off switch on the unit, so operation begins as soon as a power adapter is connected.
power adapter. There is no on/off switch on the unit, so operation begins as soon as a power adapter is connected.
To connect the power supply
1 Attach the output lead from the power adapter to the
1 Attach the output lead from the power adapter to the
5V
socket on the rear panel of the unit. See Figure 3-11.
4
5V
2.5A
IND
OOR
USE
ONLY
USE
R
CONSOLE
OPTIONS
Figure 3-11. Attaching the power adapter lead to the power input socket.
2 Connect the IEC connector of the supplied country-specific power lead to the socket of the power adapter. See Figure 3-12
Figure 3-12. Attaching the IEC connector of the power lead to the adapter.
3 Connect the power lead to a nearby main supply socket.
Note: Both the unit and its power supply generate heat when in operation and will become warm to the touch. Do not enclose
them or place them in locations where air cannot circulate to cool the equipment. Do not operate the equipment in ambient tem-
peratures exceeding 104° F (40° C). Do not place the products in contact with equipment whose surface temperature exceeds
104° F (40° C).
them or place them in locations where air cannot circulate to cool the equipment. Do not operate the equipment in ambient tem-
peratures exceeding 104° F (40° C). Do not place the products in contact with equipment whose surface temperature exceeds
104° F (40° C).