Black Box KV3004A Manual De Usuario

ServSwitch Wizard VGA (USB)

724-746-5500   |   blackbox.com 

Page 16

724-746-5500   |   blackbox.com 

3.2.2 Computer systems

Each computer system is connected to the ServSwitch Wizard VGA (USB) unit using up to three cables for the KV3004A and up
to six cables for the KV3204A, KV3304A and KV3404A.

To connect a computer system
1  Ensure that power is disconnected from the ServSwitch Wizard VGA (USB) unit and the system to be connected.

2  Use a USB cable (type-A to type-B) to link a USB port on the computer system to the USB port of the required channel on the

rear of the unit. See Figure 3-7.

Figure 3-7. Connecting the USB and speaker leads from a computer to the ServSwitch Wizard VGA (USB) unit.

3  If required, use a stereo audio link cable (3.5-mm jacks at either end) to link the speaker port on the computer system to the

audio port of the required channel on the rear of the unit. See Figure 3-7.

4  Single screen units: Link the video output of the computer’s graphic port to the VGA port of the required channel on the rear

of the unit. See Figure 3-8.

Figure 3-8. Connecting the video lead

from a computer to a VGA input port.

During initial power up, the Wizard unit will attempt to read the EDID information from the connected display(s). See Section
3.2.6 for details.