ZyXEL Communications GS1510-24 Manual De Usuario
Chapter 3 Hardware Overview
GS1510 Series User’s Guide
30
1
Open the transceiver’s latch (latch styles vary).
Figure 12 Opening the Transceiver’s Latch Example
2
Pull the transceiver out of the slot.
Figure 13 Transceiver Removal Example
3.1.3 The RESET Button
Reset the Switch to its factory default configuration via the RESET button. Press
the RESET button for at least five seconds and then release. The Switch
automatically reboots and reloads its factory default configuration file. The RESET
button is on the front panel of the Switch.
the RESET button for at least five seconds and then release. The Switch
automatically reboots and reloads its factory default configuration file. The RESET
button is on the front panel of the Switch.
Note: When you use the RESET button all of your configuration settings will be lost.
Use the default IP address (192.168.1.1) and user name (admin) and password
(1234) to log back into the Switch. It may take up to 2 minutes for the Switch to
restart when you reload the default configuration file.
(1234) to log back into the Switch. It may take up to 2 minutes for the Switch to
restart when you reload the default configuration file.
3.2 LEDs
The following table describes the LEDs.
Table 2 LEDs
LED
STATUS
DESCRIPTION
PWR
Green
On
The system is turned on.
Off
The system is off.
SYS
Green
On
The system is on and functioning properly.
Off
The system is off or is malfunctioning.