ZyXEL Communications IES-5000 Manual De Usuario

IES-5000 Series User’s Guide

30

Chapter 3 Hardware Installation and Connections

Figure 6   Chassis Frame Ground

This section shows you how to install and remove chassis cards.

• Install the line cards in the IES-5000 starting from slot 3 downwards.
• Install the line cards in the IES-5005 starting from slot 2 downwards.
• Install management switch cards in slot 1 and/or 2 on the IES-5000. 
• Install a management switch card in slot 1 on the IES-5005. 

Use the following procedure to install management switch cards and DSL line cards in the 
chassis.

1 Grasp the center of the front panel of the card with one hand and place the other hand 

under the card to support it.

2 Insert the card halfway into the slot and spread the two ejector levers outward. Make sure 

the ejector levers are perpendicular to the front panel.

3 Slide the card into the slot until it makes contact with the backplane. The ejector levers 

should be at a small angle to the front panel now.

4 Push the two ejector levers firmly until they are flush with the front panel.

5 Tighten the two thumbscrews.