Microsoft ES4649 Manual De Usuario
Multicast Filtering Commands
4-233
4
Example
The following shows how to configure the default timeout to 300 seconds:
The following shows how to configure the default timeout to 300 seconds:
Related Commands
Static Multicast Routing Commands
ip igmp snooping vlan mrouter
This command statically configures a multicast router port. Use the no form to
remove the configuration.
remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
• vlan-id - VLAN ID (Range: 1-4093)
• interface
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1-8)
- port - Port number. (Range: 1-25/49)
- port - Port number. (Range: 1-25/49)
• port-channel channel-id (Range: 1-32)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not always be
able to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on your router, you can manually configure that interface to join all the
current multicast groups.
able to locate the IGMP querier. Therefore, if the IGMP querier is a known
multicast router/switch connected over the network to an interface (port or
trunk) on your router, you can manually configure that interface to join all the
current multicast groups.
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#
Console(config)#
Table 4-76 Static Multicast Routing Commands
Command
Function
Mode
Page
ip igmp snooping vlan
mrouter
Adds a multicast router port
GC
show ip igmp snooping
mrouter
Shows multicast router ports
PE