Microsoft ES4649 Manual De Usuario
Command Line Interface
4-280
4
Example
Related Commands
ip ospf hello-interval
This command specifies the interval between sending hello packets on an interface.
Use the no form to restore the default value.
Use the no form to restore the default value.
Syntax
ip ospf hello-interval seconds
no ip ospf hello-interval
no ip ospf hello-interval
seconds - Interval at which hello packets are sent from an interface. This
interval must be set to the same value for all routers on the network.
(Range: 1-65535)
interval must be set to the same value for all routers on the network.
(Range: 1-65535)
Command Mode
Interface Configuration (VLAN)
Default Setting
10 seconds
Command Usage
Hello packets are used to inform other routers that the sending router is still
active. Setting the hello interval to a smaller value can reduce the delay in
detecting topological changes, but will increase routing traffic.
active. Setting the hello interval to a smaller value can reduce the delay in
detecting topological changes, but will increase routing traffic.
Example
ip ospf priority
This command sets the router priority used when determining the designated router
(DR) and backup designated router (BDR) for an area. Use the no form to restore
the default value.
(DR) and backup designated router (BDR) for an area. Use the no form to restore
the default value.
Syntax
ip ospf priority priority
no ip ospf priority
no ip ospf priority
priority - Sets the interface priority for this router. (Range: 0-255)
Command Mode
Interface Configuration (VLAN)
Console(config)#interface vlan 1
Console(config-if)#ip ospf dead-interval 50
Console(config-if)#
Console(config-if)#ip ospf dead-interval 50
Console(config-if)#
Console(config)#interface vlan 1
Console(config-if)#ip ospf hello-interval 5
Console(config-if)#
Console(config-if)#ip ospf hello-interval 5
Console(config-if)#