Microsoft ES4649 Manual De Usuario

Descargar
Página de 674
Configuring the Switch
3-34
3
CLI – Enter the IP address of at least one SMTP server, set the syslog severity level 
to trigger an email message, and specify the switch (source) and up to five recipient 
(destination) email addresses. Enable SMTP with the logging sendmail command 
to complete the configuration. Use the show logging sendmail command to display 
the current SMTP configuration.
Renumbering the Stack
If the units are no longer numbered sequentially after several topology changes or 
failures, you can reset the unit numbers using the “Renumbering” command. Just 
remember to save the new configuration settings to a startup configuration file prior 
to powering off the stack Master. 
Command Usage
• The startup configuration file maps configuration settings to each switch in the 
stack based on the unit identification number. You should therefore remember to 
save the current configuration after renumbering the stack. 
• For a line topology, the stack is numbered from top to bottom, with the first unit in 
the stack designated at unit 1. For a ring topology, the Master unit taken as the top 
of the stack and is numbered as unit 1, and all other units are numbered 
sequentially down through the ring. 
Web – Click System, Renumbering.
Figure 3-21   Renumbering the Stack
Console(config)#logging sendmail host 192.168.1.4
Console(config)#logging sendmail level 3
Console(config)#logging sendmail source-email
big-wheels@matel.com
Console(config)#logging sendmail destination-email
chris@matel.com
Console(config)#logging sendmail
Console(config)#exit
Console#show logging sendmail
SMTP servers
-----------------------------------------------
1. 192.168.1.4
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. chris@matel.com
SMTP source email address: big-wheels@matel.com
SMTP status:
Enabled
Console#