Alcatel-Lucent 6600 Series Manual De Usuario

Gigabit Ethernet Uplink Modules

OmniSwitch 6600 Series Chassis and Hardware Components

page 2-28

OmniSwitch 6600 Series Hardware Users Guide

Stacking modules are used to connect OmniSwitch 6624, 6600-U24, and 6648 switches in a stack. The 
stack acts as a virtual chassis, with switches serving as primary and secondary management modules and 
Network Interface (NI) modules. For detailed information, refer to 

For information on installing stacking modules, refer to 

. For information on removing stacking 

modules, refer to 

. For important installation restrictions, refer to the chassis front panel informa-

tion on pages 

 and 

, as well as 

.

Note. Stacking modules cannot be hot swapped at any time. For more information on hot swapping, refer 
to 

 

Number of ports

2

Power

Approximately 8 Watts

Data Speed

1 Gigabit per second per stacking cable installed 

Connector type

High Speed Serial Data Connector (HSSDC)

Chassis port locations

27 and 28 (OS6624 and OS6600-U24); 
51 and 52 (OS6648)

Hot-swappable with other module types?

No

LINK/ACT LEDs
Each stacking connector has a built-in corresponding LED. This LED
indicates the link and activity status for each connector. The LED dis-
plays green when a valid cable connection exists. Flashes green as data is
being transmitted to, or received from, the adjacent switch in the stack.

HSSDC Stacking Connectors 
The stacking module provides two dedicated High Speed Serial Data
Connectors (HSSDCs). These connectors are used to connect OS6624/
OS6600-U24/OS6648 switches in a stack. For detailed information on
stacks, refer to