Alcatel-Lucent 6600 Series Manual De Usuario
Removing MiniGBICs
OmniSwitch 6600 Series Chassis and Hardware Components
page 2-36
OmniSwitch 6600 Series Hardware Users Guide
April 2004
2 Push the MiniGBIC into the slot until it is completely inserted and securely seated in the
OS6600-GNI-U2 module on OmniSwitch 6624, 6600-U24, and 6648 switches, as shown.
OS6600-GNI-U2 module on OmniSwitch 6624, 6600-U24, and 6648 switches, as shown.
Installed MiniGBIC (OS6648 Shown)
Removing MiniGBICs
MiniGBICs modules can be hot swapped. You are not required to power off the switch before removing a
MiniGBIC from the uplink module. To remove a MiniGBIC from the uplink module, follow the steps
below:
MiniGBIC from the uplink module. To remove a MiniGBIC from the uplink module, follow the steps
below:
Anti-Static Warning. Before handling any components, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the MiniGBIC, as well as the switch
and uplink module.
strap, or by grounding yourself properly. Static discharge can damage the MiniGBIC, as well as the switch
and uplink module.
1 On OmniSwitch 6624, 6600-U24, and 6648 switches only, make sure that the captive screws on the
OS6600-GNI-U2 are tightened and the module is securely installed in the chassis.
OS6600-GNI-U2 are tightened and the module is securely installed in the chassis.
2 There is a small removal handle at the front of the MiniGBIC transceiver. Carefully lift this handle;
then, grasp the handle and carefully pull the MiniGBIC from the module.
then, grasp the handle and carefully pull the MiniGBIC from the module.
3 Store the MiniGBIC in a secure, static-free location. Placing the MiniGBIC in an anti-static bag is
recommended.
recommended.
EXP
ANSION/S
TA
CKING
5 1
5 2