Siemens Module B3 Manual De Usuario
Automation and Drives - SCE
T I A Training Document
Page 53 of 64
Module
22.
The PID controller can now be parameterized with the tool Parameterize PID Control.
Then, the DB is saved (
→ Save) and loaded to the PLC (→ Load).
Now, a curve plotter can be started in order to monitor the performance of the
controlled system.
Preface Fundamentals Discontinuous Action Controllerr Controller Block (S)FB41 Setting the System Appendix
Start ‘Curve plotter’
Click on ‘Load’
Click on ‘Save’
23. With the curve plotter, the curves for setpoint, actual value and manipulated variable can be
recorded.
24. The program is started by setting the key switch to RUN.
B3
Issued: 02/2008 Control Engineering with STEP 7