Acer G610 Manual De Usuario
131
System rack installation
Vertical mounting hole pattern
The four vertical rails of a rack contain mounting holes arranged in a
manner shown in the figure below:
manner shown in the figure below:
The system occupies 6U in the rack. Count the U positions and hole
numbers from the bottom up.
numbers from the bottom up.
Note: The unit of measurement used in this document is "U" (1U
= 1.75 inches or 44.45 mm). The total sum of the heights of all
components in the rack measured in "U" cannot exceed the
height of the rack. For more information, please refer to the
rack’s documentation.
= 1.75 inches or 44.45 mm). The total sum of the heights of all
components in the rack measured in "U" cannot exceed the
height of the rack. For more information, please refer to the
rack’s documentation.
The distance from the center of two holes with closer spacing to the
center of the next pair is equivalent to 1U.
center of the next pair is equivalent to 1U.
When installing components, you must start your measurement from
the center of the two holes with closer spacing. Otherwise, the screw
holes on the component may not match with those on the rack.
the center of the two holes with closer spacing. Otherwise, the screw
holes on the component may not match with those on the rack.
AA G600.book Page 131 Thursday, August 23, 2001 2:31 PM