Intel 5800/120Ld Manual De Usuario
B-4 Management Workstation Application
Installing MWA
To use MWA several procedures must be performed to configure the managed
server and the management PC. For ease of installation these procedures should
be performed in the order presented in the following sections. Installation
procedures include procedures to be performed at the server and at the
management PC.
server and the management PC. For ease of installation these procedures should
be performed in the order presented in the following sections. Installation
procedures include procedures to be performed at the server and at the
management PC.
Server Procedures
!
Create a server system generation diskette (SG) containing essential
server networking information.
server networking information.
!
Run the BIOS Setup Utility making the changes to BIOS necessary for
server acceptance of MWA support.
server acceptance of MWA support.
Management PC Procedures
!
Install MWA software on the management PC.
!
Configure and register SG information within MWA at the management
PC.
PC.
Creating a Server System Generation Diskette (SG)
For the management PC to connect with a server, server system generation (SG)
information must be configured and registered on MWA software running on
the management PC.
information must be configured and registered on MWA software running on
the management PC.
In this procedure you will create a diskette containing your server's SG
information. In the following section, you will register the SG information with
MWA.
information. In the following section, you will register the SG information with
MWA.
1. Prepare a floppy disk, formatted with MS-DOS.
2. Insert the E
XPRESS
B
UILDER
CD in the server’s CD-ROM drive, and boot the
server from the CD. The E
XPRESS
B
UILDER
menu displays.
3. Select
Custom Setup.
4. Select System Management.
5. Select Network Setup. The Network setup program starts.
6. Insert the floppy disk prepared in step 1 into the server's diskette drive and
press the ESC key.