Intel ECB-862 Manual De Usuario

ECB-862/862L User’s Manual 13  

 

This chapter explains you the instructions of how to set up your system. The additional 
information shows you how to install M-Systems’ DiskOnChip and program the Watchdog 
Timer. 

1.  Turn off the power supply. 

2.  Insert the DIMM module (be careful with the orientation). 

3.  Insert all external cables for hard disk, floppy, keyboard, mouse, USB etc. except for flat 

panel. A CRT monitor must be connected in order to change CMOS settings to support 
flat panel. 

4.  Connect power supply to the board via the PWR1. 

5.  Turn on the power. 

6. Enter the BIOS setup by pressing the delete key during boot up. Use the “Auto 

Configuration with Optimal Settings” feature. The Peripheral Setup and the Standard 
CMOS Setup Window must be entered and configured correctly to match the particular 
system configuration. 

7.  If TFT panel display is to be utilised, make sure the panel voltage is correctly set before 

connecting the display cable and turning on the power.  

 

Always completely disconnect the power cord from your chassis or power 
cable from your board whenever you work with the hardware. Do not make 
connections    while the power is on. Sensitive electronic components can 
be damaged by sudden power surges. Only experienced electronics 
personnel should open the PC chassis.  

Always ground yourself to remove any static charge before touching the 
board. Modern electronic devices are very sensitive to static electric 
charges. As a safety precaution, use a grounding wrist strap at all times. 
Place all electronic components in a static-dissipative surface or static-
shielded bag when they are not in the chassis.