Gateway 7210 Manual De Usuario
70
Replacing and Adding Internal Devices
Replacing the PS/2 power supply
The PS/2 power supply does not support fault tolerance or hot-swapping. If
the power supply fails, you must replace it.
the power supply fails, you must replace it.
To replace the PS/2 power supply:
1
Turn off the system and disconnect the power cord and all peripherals.
2
Open the case. (See “Opening the case” on page 23 and “Preventing static
electricity discharge” on page 22.)
electricity discharge” on page 22.)
3
Disconnect the power supply connectors from all internal devices,
including the 3.5-inch diskette drive, the CD drive, and all hard drives.
including the 3.5-inch diskette drive, the CD drive, and all hard drives.
4
Disconnect the main power supply connector to the system board, by
pressing on the tab to release the connector, then gently pull the
connector from the board.
pressing on the tab to release the connector, then gently pull the
connector from the board.
5
While supporting the power supply with one hand, remove the screws
securing the power supply to the back panel and the top panel.
securing the power supply to the back panel and the top panel.
8505945.book Page 70 Thursday, March 9, 2000 2:13 PM