Fujitsu TX150 S3 Manual De Usuario
U41604-Z156-1-76
Options Guide
5
2
Procedure
V
CAUTION!
The actions described in these instructions should only be performed by
technicians, service personnel or technical specialists. Equipment
repairs should only be performed by authorized, qualified staff. Any
unauthorized opening and improper repairs could expose the user to
risks (electric shock, energy hazards, fire hazards) and could also
damage the equipment. Please note that any unauthorized opening of
the device will result in the invalidation of the warranty and exclusion from
all liability.
technicians, service personnel or technical specialists. Equipment
repairs should only be performed by authorized, qualified staff. Any
unauthorized opening and improper repairs could expose the user to
risks (electric shock, energy hazards, fire hazards) and could also
damage the equipment. Please note that any unauthorized opening of
the device will result in the invalidation of the warranty and exclusion from
all liability.
Ê
First of all please familiarize yourself with the safety instructions in the
section chapter “Safety notes” on page 7 et seqq. .
section chapter “Safety notes” on page 7 et seqq. .
Ê
Ensure that all required manuals (see “Additional documentation about the
server” on page 1) are available, printing out the PDF files if necessary. You
will definitely need the Operating Manual for the server and the Technical
Manual for the system board.
server” on page 1) are available, printing out the PDF files if necessary. You
will definitely need the Operating Manual for the server and the Technical
Manual for the system board.
Ê
Shut down the server correctly, switch it off, pull out the power plug(s), and
open the server as described in the chapter “Preparation” on page 13 et
seqq. .
open the server as described in the chapter “Preparation” on page 13 et
seqq. .
Ê
Extend or upgrade your server as described in the relevant chapter.
I
The Operating Manual for the server describes how you
install/remove the hot-plug components.
install/remove the hot-plug components.
I
Procedures which are identical for the floorstand and rack models are
only described for the floorstand model.
only described for the floorstand model.
Ê
Close the server, connect it to the power outlet, and switch it on as described
in the chapter “Completion” on page 59 et seqq. .
in the chapter “Completion” on page 59 et seqq. .
Ê
Start the operating system and, if necessary, configure it as required (see
the Operating Manual).
the Operating Manual).