Fujitsu RX200 S2 Manual De Usuario
254
Chapter 9 Operation and Maintenance
■ Floppy Disk Drive
●
Cannot read or write to the floppy disk.
The head may be dirty. Clean the drive using a cleaning disk.
For cleaning methods, refer to "9.1.2 Cleaning" (
●
Cannot write to the floppy disk.
The write protection of the floppy disk may be applied. Flip the switch on the disk to allow writing.
■ CD-ROM Drive Unit
●
Cannot read data.
• Check to see whether the CD-ROM is inserted properly.
If it is not inserted, correctly insert the CD-ROM so that the label is facing up.
• Check to see whether the CD-ROM is not dirty.
If it is dirty, wipe it with a soft, dry cloth.
• Check to see whether the CD-ROM is not scratched or bent.
If scratched or damaged, replace the CD-ROM.
●
The unit does not operate properly.
• The CD-ROM drive unit may not be recognized at the next startup after installation of fiber channel
card in a Windows Server 2003 server. Perform the steps in "
in "7.5.2 Installable Expansion Cards and Notes", then it will be recognized.
• Check to see whether the internal cable is connected properly.
If it is not connected, correctly connect the internal cable. For the connection location, refer to "7.10
■ SCSI Device (Internal/External)
●
The unit does not operate properly.
• Check to see whether the internal cable is connected properly.
If it is not connected, correctly connect the internal cable.
• Check to see whether the jumper pins are set properly.
If they are not set, correctly set the jumper pins. For settings, refer to "8.1 Jumper Pin Settings"
• Check to see whether the SCSI IDs and terminator are set properly.
If they are not set, correctly set the SCSI ID and terminator.